摘要：An SISO IEEE 802.11 baseband OFDM transceiver ASIC is implemented. The chip can support all of the SISO IEEE 802.11 work modes by optimizing the key module and sharing the module between the transmitter and receiver. The area and power are decreased greatly compared with other designs. The baseband prototype has been verified under the WLAN baseband test equipment and through transferring the video. The 0.18/zm 1P/6M CMOS technology layout is finished and the chip is fabricated in SMIC, which occupies a 2.6 × 2.6 mm^2 area and consumes 83 mW under typical work modes.

摘要：Precoding and space-time block coding （STBC）techniques using the uniform channel decomposition （UCD）are proposed to improve the bit error rate （BER） of themultiple-antenna communication system, but at a cost of areduced data rate. In order to achieve a higher overall systemperformance, a novel adaptive transceiver architecture whichflexibly combines both UCD and UCD ＋ STBC technologies isproposed. The channel state information （CSI） feedback pathwas added to the precoder to select which coding method wasto be used, i.e. UCD alone or UCD ＋ STBC. With thesmaller constellation sizes, Matlab simulation results showthat, the adaptive transceiver architecture will select the UCD-only mode under the higher SNR conditions in order to achievea higher bit rate. The UCD ＋ STBC mode will be selectedunder the lower SNR conditions （e. g., SNR 〈 10 dB） inorder to maintain good BER performance at the cost of areduced data rate. This architecture was implemented andverified using both UMC 0.18 ASIC process technology and aXilinx xc4vlx Virtex-4 FPGA at 150 MHz. The simulationresults demonstrate that the required number of reconfigurablearithmetic unit slices grows linearly with the channel matrixsize, while the number of adder array unit and reconfigurablelogic unit slices increases slightly with the constellation size.

摘要：In this article, we present multiple-input receiver architecture for MIMO (Multiple-Input Multiple-Output) wireless communication applications. The proposed implementation is provided by a defined number of identical receiver units that are fed by a RF modulated signal on specific carrier frequency, power strength and initial phase. These units carry out the corresponding amplification, filtering and demodulation procedures. Details on design and implementation of this Printed-Circuit-Board are introduced and further discussed. Experimental results are also presented, allowing the validation of investigation on the performance of the current receiver architecture. Besides, these measurements indicate that the proposed device, combining with a suitable antenna array, provides a versatile receiver platform for baseband signal processing. The incoming RF modulated signals have frequencies on the range of 2.4 GHz, several phases, magnitudes and modulation modes. From these, it seems that the proposed receiver implementation supports MIMO communication and multiple port channel characterization applications at 2.4 GHz ISM (Industrial, Scientific and Medical) band.