摘要：This paper demonstrates wide-band CMOS VCO based on the transformer feedback from traditional circuit to our proposed work. The start up condition of the traditional cross-coupled pair is expressed by the high frequency model. The wide band technique of this structure is derived with the help of the high frequency model of the transistor. Therefore, the wide band CMOS VCO based on the common source transformer feedback topology can achieves the high performance in the low voltage and low phase noise. The measurement result of the VCO exhibits the figure of merit, core power consumption and output power at supply voltage 0.8 V are –193.1 dBc/Hz, 4.4 mW and –2.3 dBm, respectively. The phase noise is –124.3 dBc/Hz at 1 MHz offset under the operation frequency 5.8 GHz. And the tuning range of the circuit can obtain 28%, this VCO is fabricated in TSMC 0.18 μm 1P6MCMOS process.

摘要：在分析低压电器性能仿真要素的基础上,应用灰色关联分析,对低压电器的设计仿真软件性能进行了综合评价。该方法能够较好地处理多因素相互影响、含未知或非确知信息系统的设计质量综合评价问题。

摘要：This paper presents the design of a low power LNA with second stage that uses a notch filter for DS-UWB application. The LNA employs a current reuse structure to reduce the power consumption and an active second order notch filter to produce band rejection in the 5 - 6 GHz frequency band. The input reflection coefficient S11 and output reflection S22 are both less than –10 dB. The maximum power gain S21 is 15 dB while the maximum rejection ratio is over –10 dB at 4.8 GHz. The minimum noise figure is 5 dB. The input referred third-order intercept point (IIP3) is –7 dBm at 6 GHz. The power consumption is 6.4 mW from a 1-V power supply.

摘要：A high power buck-boost switch-mode LED driver delivering a constant 350 mA with a power efficient current sensing scheme is presented in this paper. The LED current is extracted by differentiating the output capacitor voltage and maintained by a feedback. The circuit has been fabricated in a standard 0.35 μm AMS CMOS process. Measurement results demonstrated a power-conversion efficiency over 90% with a line regulation of 8%/V for input voltage of 3.3 V and current output between 200 mA and 350 mA.

摘要：This paper presents and tests three earthing systems (TT, TN and IT) for Micro-Grid (MG) protection against various fault types when the MG transferred to the islanding mode. The main contribution of this work is including the models of all micro sources which interfaced to the MG by power electronic inverters. Inverters in turns are provided with current limiters and this also included with the inverter models to exactly simulate the real situation in the MG during fault times. Results proved that the most suitable earthing system for MG protection during the islanding mode is the TN earthing system. That system leads to a suitable amount of fault current sufficient to activate over current pro-tection relays. With using TN earthing system, touch voltages at the faulted bus and all other consumer’s buses are less than the safety limited values during islanding mode. For the two others earthing systems (TT and IT), fault currents are small and nearly equal to the over load currents which make over current protection relay can not differentiate between fault currents and overload currents. All models of micro sources, earthing systems, inverters and control schemes are built using Matlab?/Simulink? environment.

摘要：星载光谱仪的数据接口为LVDS接口,为快速地将其转换为地面民用设备,设计了LVDS转千兆以太网适配器。适配器采用FPGA为主控芯片,接收光谱仪发送的串行的图像数据,并将其封装为以太网帧格式,然后通过网口芯片传输给上位机;同时适配器接收上位机发送的命令数据,并转发给光谱仪。实验结果表明,适配器在传输速率为43 Mbit/s时,连续运行48 h,误码率为0,在实验室条件和自然条件下均能稳定传输数据,可作为光谱仪的转换接口。

摘要：A new design technique employing CMOS Current Feedback Operational Amplifier (CFOA) is presented. This design approach applies CFA OTA as input stage cascaded with class AB cross-coupled buffer stage. The performance parameters of CMOS CFOA such as bandwidth, slew rate, settling time are extensively improved compared with conventional CFOA. These parameters are very important in high frequency applications that use CMOS CFOA as an active building block such as A/D converters, and active filters. Also the DC input offset voltage and harmonic distortion (HD) are very low values compared with the conventional CMOS CFOA are obtained. P-Spice simulation results using 0.35 μm MI-ETEC CMOS process parameters shows considerable improvement over existing CMOS CFOA simulated model. Some of the performance parameters for example are DC gain of 67.2 dB, open-loop gain bandwidth product of 104 MHz, slew rate (SR+) of +91.3 V/μS, THD of -67 dB and DC input offset voltage of -0.2 mV.

摘要：为有效解决主动配电网中电压波动问题,研制了基于TMS320F2812实现的30kVA动态电压恢复器。设计了主电路、DSP电路、电压电流测量电路、PWM驱动电路和故障保护电路。主电路功率器件采用智能功率模块PM300DVA120,为提高测量精度,采用可实现6通道同时采样的16位A/D芯片AD7656。基于同步参考坐标理论的电压定向控制策略,可实现输出补偿电压的同相反相控制。开关频率10kHz,死区时间5μs的稳态和暂态实验结果表明,所研制的DVR系统具有良好的动静态响应性能。此DVR系统可用于对电压稳定要求较高的主动配电网系统。

摘要：随着特高压的推广,特高压输电线路的抗冰融冰正成为研究的热点。特高压输电线路由于线径粗、线路长,所需融冰电流与装置容量大,其电流融冰是一个研究的难点。针对特高压输电线路的特点提出了分段直流融冰方法,其将特高压输电线路分成若干段,选取重覆冰区的线路段设置直流融冰点与融冰短路点,可以有效减小融冰装置容量。针对特高压输电线路融冰所需直流融冰装置容量大特点,为了减小融冰装置网侧电流的谐波畸变率,采用24脉波整流变压器+多台整流器并联方式,可以有效减小直流融冰装置对网侧电源的干扰,并可减小输出直流电压纹波因数。最后对所设计的特高压输电线路直流融冰装置进行了仿真研究,采用24脉波整流变压器+多台整流器并联方式后,可以有效消除整流器引起的输入侧电流中5次和7次谐波电流,整流变压器输入侧电流低次谐波总畸变率仅为0.51%,输出直流电压脉波数为24,电压纹波因数仅为0.616。仿真结果证明了所设计特高压直流融冰装置的可行性与正确性。