摘要：A novel low-voltage,low constant-impedance switch is proposed, which not only eliminates the parasitic capacitor but also reduces the variation of switch ＂on＂ resistance. With the gain-boost technology,the operational transconductance amplifier used in this analog-to-digital converter （ADC） achieves enough DC gain and unity-gain frequency under the low voltage supply and to guarantee the performance of the sample and hold circuit （S/H） and the sub-stages. Based on these methods,a 10bit 100Msps pipelined ADC is fabricated in a 0. 18μm CMOS process and operates under a 1.8V voltage supply. The ADC achieves an SNR of 54. 2dB （input frequency of 6.26MHz） and an SNR of 49. 8dB （input frequency of 48. 96MHz） when the sampling frequency is 100MHz.

摘要：This paper describes a 3.0V, 10b,40Msample/s analog-to-digital converter （ADC） fabricated in a 0.25μm CMOS technology. Through the sharing an amplifier between two successive pipeline stages, the converter is realized using just four amplifiers with a separate sample-and-hold block. It employs two key techniques： a high bandwidth low-power gain-boosting telescopic amplifiers technique and a low power low offset dynamic comparators *** ADC achieves a 8.1 effective number of bits,a maximum differential nonlinearity of a 0.85 least significant bit（LSB）, and maximum integral nonlinearity of 2.2LSB for a 0.5MHz input at full sampling rate. It occupies 1.24mm^2 ,which also includes a bandgap and a voltage reference circuit and dissipates only 59mW.

摘要：A 13bit,pipelined analog-to-digital converter （ADC） designed to achieve high linearity is described. The high linearity is realized by using the passive capacitor error-averaging technique to calibrate the capacitor mismatch error, a gain-boosting opamp to minimize the finite gain error and gain nonlinearity,a bootstrapping switch to reduce the switch on-resistor nonlinearity, and an anti-disturb design to reduce the noise from the digital supply. This ADC is implemented in 0.18μm CMOS technology and occupies a die area of 3.2mm^2 , including pads. Measured performance includes - 0.18/ 0.15LSB of differential nonlinearity, -0.35/0.5LSB of integral nonlinearity, 75.7dB of signal-to-noise plus distortion ratio （SNDR） and 90. 5 dBc of spurious-free dynamic range （SFDR） for 2.4MHz input at 2.5MS/s. At full speed conversion （5MS/s） and for the same 2.4MHz input, the measured SNDR and SFDR are 73.7dB and 83.9 dBc, respectively. The power dissipation including output pad drivers is 21mW at 2.5MS/s and 34mW at 5MS/s,both at 2.7V supply.

摘要：Comparator offset cancellation and capacitor self-calibration techniques used in a successive approximation analog-to-digital converter （SA-ADC） are described. The calibration circuit works in parallel with the SAADC by adding additional calibration clock cycles to pursue high accuracy and low power consumption, and the calibrated resolution can be up to 14bit. This circuit is used in a 10bit 3Msps successive approximation ADC. This chip is realized with an SMIC 0. 18μm 1.8V process and occupies 0.25mm^2 . It consumes 3. 1mW when operating at 1.8MHz. The measured SINAD is 55. 9068dB, SFDR is 64. 5767dB, and THD is - 74. 8889dB when sampling a 320kHz sine wave.

摘要：A CMOS folding and interpolating analog-to-digital converter (ADC) for embedded application is *** circuit is fully compatible with standard digital CMOS technology.A modified folding block implemented without resistor contributes to a small chip *** the input stage,offset averaging reduces the input capacitance and the distributed track-and-hold circuits are proposed to improve signal-to-noise-plus-distortion *** 200Ms/s 8bit ADC with 177mW total power consumption at 3.3V power supply is realized in standard digital 0.18μm 3.3V CMOS technology.

摘要：A 1.8V 8b 125Msample/s pipelined A/D converter is *** efficiency is optimized by size scaling down scheme using low power single stage cascode amplifier with a gain boosted *** clock tree and local generators are employed to avoid loss and overlap of clock *** ADC achieves a signal-to-noise-and-distortion ratio (SNDR) of 49.5dB(7.9ENOB) for an input of 62MHz at full speed of 125MHz,consuming only *** is implemented in 0.18μm CMOS technology with a core area of 0.45mm 2.

摘要：This paper makes a review of state-of-the- arts designs of successive-approximation register analog-to-digital converters （SAR ADCs）. Methods and technique specifications are collected in view of innovative ideas. At the end of this paper, a design example is given to illustrate the procedure to design an SAR ADC. A new method, which extends the width of the internal clock, is also proposed to facilitate different sampling frequencies, which provides more time for the digital-to-analog convert （DAC） and comparator to settle. The 10 bit ADC is simulated in 0.13 μm CMOS process technology. The signal-to-noise and distortion ratio （SNDR） is 54.41 dB at a 10 MHz input with a 50 MS/s sampling rate, and the power is 330 μW.