摘要：To design effective and easy-to-manufacture conductive heat channels, a heuristic method by emulating the natural branch systems is suggested. The design process of the method is divided into two steps, which are the principal channel design and the lateral channel design. During the process, the width of each channel is controlled by the bifurcation law, and the end point of the channel is located at the point with the maximum temperature while the start points of the principal channel and the lateral channel are respectively determined by the location of the heat sink and the law of the minimum thermal resistance. Four design examples with different boundary conditions are studied by the suggested method, and the design results are compared with that of the traditional structural topology optimization method. Not only lower maximum temperature and relatively uniform distribution of temperature are obtained by the suggested method, but also straight channels are achieved without gray element, which is easy to manufacture. The suggested method inspired by the natural branch systems can provide an effective solution for heat channel design in the heat dissipation structures.

摘要：thermal performance was the most important factor in the development of borehole heat exchanger utilizing geothermal energy. The thermal performance was affected by many different design parameters, such as configuration type and borehole size of geothermal heat exchanger. These eventually determined the operation and cost efficiency of the geothermal heat exchanger system. The main purpose of this work was to assess the thermal performance of geother^nal heat exchanger with variation of borehole sizes and numbers of U-tubes inside a borehole. For this, a thermal response test rig was established with line-source theory. The thermal response test was performed with in-line variable input heat source. Effective thermal conductivity and thermal resistance were obtained from the measured data. From the measurement, the effective thermal conductivity is found to have similar values for two- pair type （4 U-tubes） and three-pair type （6 U-tubes） borehole heat exchanger systems indicating similar heat transfer ability. Meanwhile, the thermal resistance shows lower value for the three-pair type compared to the two-pair type. Measured data based resistance have lower value compared to computed result from design programs. Overall comparison finds better thermal performance for the three-pair type, however, fluctuating temperature variation indicates complex flow behavior inside the borehole and requires further study on flow characteristics.