摘要：We consider the robust stabilization problem for discrete-time Takagi-Sugeno （T S） fuzzy systems with time- varied delays subjected to input saturation. We design static and dynamic anti-windup fuzzy controllers to ensure the convergence of all admissible initial states within the domain of attraction. Based on the project lemma and classical sector conditions, the conditions for the existence of solutions to this problem are obtained and expressed in terms of a set of linear matrix inequalities. Finally, a numerical example is provided to illustrate the effectiveness of the proposed design approach.

摘要：This paper describes a large tuning range low phase noise voltage-controlled ring oscillator （ring VCO） based on a different cascade voltage logic delay cell with current-source load to change the current of output node. The method for optimization is presented. Furthermore, the analysis of performance of the proposed ring VCO is confirmed by the measurement results. The three-stage proposed ring VCO was fabricated in the 180-nm CMOS process of SMIC. The measurement results show that the oscillator frequency of the ring VCO is from 0.77O to 5.286 GHz and the phase noise is 97.93 dBc/Hz at an offset of 1 MHz from 5.268 GHz with a total power of 15.1 mW from a 1.8 V supply while occupying only 0.00175 mm2 of the core die area.

摘要：A strain-introduced Mach-Zehnder interferometer (MZI) interleaver on lithium niobate (LiNbO3 ) is proposed. The structure of the strain-introduced waveguide is designed in detail, and is produced by depositing a SiO2 film on the annealed proton-exchanged LiNbO3 waveguide. Considering the sensitivities of the edge strain to the deposition temperature and the thickness of the SiO2 film, an optimum design of 50 GHz interleaver on this structure is given through analyzing the effective index changes for E x pq mode by finite difference method (FDM). The length of the bending waveguide in this interleaver is just two thirds of that in the conventional interleaver due to the high refractive index difference.

摘要：An exact-designed mesh shape with favorable surface accuracy is of practical significance to the performance of large cable-network antenna reflectors. In this study, a novel design approach that could guide the generation of exact spatial parabolic mesh configurations of such reflector was proposed. By incorporating the traditional force density method with the standard finite element method, this proposed approach had taken the deformation effects of flexible ring truss supports into consideration, and searched for the desired mesh shapes that can satisfy the requirement that all the free nodes are exactly located on the objective paraboloid. Compared with the conventional design method,a remarkable improvement of surface accuracy in the obtained mesh shapes had been demonstrated by numerical examples. The present work would provide a helpful technical reference for the mesh shape design of such cable-network antenna reflector in engineering practice.

摘要：According to the resonance transition between propagating surface plasmon and localized surface plasmon, we demonstrate a design of beam splitter that can split terahertz wave beams in a relatively broad frequency range. The transmission properties of the beam splitter are analyzed utilizing the finite element method. The resonance transition between two kinds of plasmons can be explained by a model of coherent electron cloud displacement.

摘要：Dipoles with Lorentz-type resonant electromagnetic responses can realise negative effective parameters in their negative resonant region. The electric dipole and magnetic dipole can realise, respectively, negative permittivity and negative permeability, so both the field distribution forms of electric and magnetic dipoles are fundamentals in designing left-handed metamaterial. Based on this principle, this paper studies the field distribution in high-permittivity dielectric materials. The field distributions at different resonant modes are analysed based on the dielectric resonator theory. The origination and influence factors of the electric and magnetic dipoles are confirmed. Numerical simulations indicate that by combining dielectric cubes with different sizes, the electric resonance frequency and magnetic resonance frequency can be superposed. Finally, experiments are carried out to verify the feasibility of all-dielectric left-handed metamaterial composed by this means.

摘要：In this paper,the authors analyze the stability of a class of interconnected systems withsubsystem unmodeled dynamics and dynamic interactions employing decentralized adaptive controllersdesigned by Wen,Zhou,and Wang (2008) in the presence of actuator *** will be shown that theglobal stability of the remaining closed-loop system is still ensured and the outputs are also regulatedto zero when some subsystems break down.

摘要：Quantum-dot cellular automata (QCA) technology has been widely considered as an alternative to complementary metal-oxide-semiconductor (CMOS) due to QCA's inherent *** interesting QCA-based logic circuits with smaller feature size,higher operating frequency,and lower power consumption than CMOS have been ***,QCA is limited in its sequential circuit design with high performance *** on a brief introduction of QCA and dual-edge triggered (DET) flip-flop,we propose two original QCA-based D and JK DET flip-flops,offering the same data throughput of corresponding single-edge triggered (SET) flip-flops at half the clock pulse *** logic functionality of the two proposed flip-flops is verified with the QCADesigner *** the proposed QCA-based DET flip-flops show higher performance than their SET counterparts in terms of data ***,compared with a previous DET D flip-flop,the number of cells,covered area,and time delay of the proposed DET D flip-flop are reduced by 20.5%,23.5%,and 25%,*** using a lower clock pulse frequency,the proposed DET flip-flops are promising for constructing QCA sequential circuits and systems with high performance.

摘要：Geographic Hypermedia(GH)is a rich and interactive map document with geo-tagged graphics,sound and video ele-ments.A Geographic Hypermedia System(GHS)is designed to manage,query,display and explore GH *** emerging geo-tagged videos and measurable images as valuable geographic data resources,this paper aims to design a web-based GHS using web mapping,geoprocessing,video streaming and XMLHTTP *** concept,data model,system design and implementation of this GHS are discussed in ***-tagged videos are modeled as temporal,spatial and metadata entities such as video clip,video path and frame-based ***,geo-tagged stereo video and derived data are modeled as interre-lated entities:original video,rectified video,stereo video,video path,frame-based description and measurable image(rectified and disparity image with baseline,interior and exterior parameters).The entity data are organized into video files,GIS layers with linear referencing and XML documents for web *** data can be integrated in HTML pages or used as Rich Internet Appli-cations(RIA)using standard web technologies such as the AJAX,*** and RIA *** SOA-based GHS is designed using four types of web services:ArcGIS Server 9.3 web mapping and geoprocessing services,Flash FMS 3.0 video streaming ser-vices and GeoRSS XMLHTTP *** applications in road facility management and campus hypermapping indicate that the GH data models and technical solutions introduced in this paper are useful and flexible enough for wider deployment as a GHS.

摘要：Dermal substitutes have provided a template for the regeneration and reconstruction of the ***,the healed skin tissue often exhibits abnormal morphology and functionality,including scarring and *** this study,a composite bioink composed of methacrylated gelatin(GelMA)and chitosan oligosaccharide(COS)was proposed for printing a dermal scaffold using digital light processing(DLP)*** GelMA/COS bioink exhibited suitable porosity,swelling,degradation rate,and mechanical *** inclusion of COS demonstrated antibacterial effects against both Gram positive and Gram-negative bacteria,while simultaneously fostering the proliferation of human dermal fibroblasts(HDFs).Additionally,the application of COS could effectively reduce the expression levels of fibrosis-related genes,such as collagen I,collagen III,and fibronectin *** three-dimensionally printed cell-laden dermal scaffold exhibited excellent shape fidelity and high cellular viability,facilitating the extension of HDFs along the scaffold and the simultaneous secretion of extracellular matrix ***,the HDF-laden dermal scaffold transplanted into full-thickness skin defect sites in nude mice was shown to accelerate wound closure,reduce inflammation,and improve wound ***,the DLP-printed dermal scaffold provides an appealing approach for effectively treating full-thickness skin defects in clinical settings.