摘要：In order to take full advantage of regeneration process to reduce fresh water consumption and avoid the accumulation of trace contaminants, regeneration reuse and regeneration recycle should be distinctive. A stepwise optimal design for water network is developed to simplify solution procedures for the formulated MINLP problem. In this paper, a feasible water reuse network framework is generated. Some heuristic rules from water reuse network are used to guide the placement of regeneration process. Then the outlet stream of regeneration process is considered as new water source. Regeneration reuse network structure is obtained through an iterative optimal procedure by taking the insights from reuse water network structure. Furthermore, regeneration recycle is only utilized to eliminate fresh water usage for processes in which regeneration reuse is impossible. Compared with the results obtained by relevant researches for the same example, the present method not only provides an appropriate regeneration reuse water network with minimum fresh water and regenerated water flow rate but also suggests a water network involving regeneration recycle with minimum recycle water flow rate. The design can utilize reuse, regeneration reuse and regeneration recycle step by step with minor water network structure change to achieve better flexibility. It can satisfy different demands for new plants and modernization of existing plants.

摘要：Two new metal-organic frameworks（MOFs）,[Cu2（H_2O）_2（BCPIA）]（BUT-20）and（Me_2NH_2）[In（BCPIA）]（BUT-21）were designed and synthesized through the solvothermal reaction between a newly created desymmetric 4-connected ligand,5-（2,6-bis（4-carboxyphenyl）pyridin-4-yl）isophthalic acid（H_4BCPIA）and Cu（NO_3）2 2.5H_2O or In（NO_3）_3·5H_2O,respectively,and characterized by single-crystal and powder Xray diffraction,thermogravimetric analysis,infrared spectroscopy,and elemental *** two MOFs have three-dimensional structures,in which both the BCPIA 4 ligand and metal-containing entities,Cu_2（COO）_4（H_2O）_2 and In（COO）_4 act as 4-connected ***,different linkage configurations of the two metal-containing nodes,quadrilateral Cu_2_TD_2（COO）_4（H_2O）_2and tetrahedral In（COO）_4,lead to distinct structural networks of BUT-20 and 21,with Nbo and Unc topologies,respectively.

摘要：Small mixer impeller design is not tailored for granulation because impellers are intended for a wide range of processes. The aim of this research was to evaluate the performances of several impellers to provide guidance on the selection and design for the purposes of granulation. Lactose granules were produced using wet granulation with water as a binder. A Kenwood KM070 mixer was used as a standard apparatus and five impeller designs with different shapes and surface areas were used. The efficacy of granulate for- mation was measured by adding an optically sensitive tracer to determine variations in active ingredient content across random samples of granules from the same size classes. It was found that impeller design influenced the homogeneity of the granules and therefore can affect final product performance. The vari- ation in active ingredient content across granules of differing size was also investigated. The results show that small granules were more potent than larger granules,

摘要：engineering complex nanocomposites that specifically target the hepatitis B virus （HBV） and overcome the limitations of current therapies such as limited efficacy and serious side effects is very challenging. Here, for the first time, the antiviral effect of engineered plasmonic gold and layered double hydroxide self-assemblies （AuNPs/LDHs） is demonstrated, using HBV as a model virus and hepatoma-derived HepG2.2.215 ceils for viral replication, assembly, and secretion of infectious virions and subviral particles. AuNPs/LDHs were obtained by a simple, cost-effective procedure in which small AuNPs （-3.5 nm） were directly obtained and organized on the surface of larger LDH nanoparticles （-150 nm） by exploiting the capability of MgLDH, ZnLDH, and MgFeLDH to manifest their ＂structural memory＂ in the aqueous solution of Au（O2CCH3）3. The self-assembly approach of AuNPs and LDHs was assessed by transmission electron microscopy （TEM）, X-ray photoelectron spectroscopy （XPS）, powder X-ray diffraction （PXRD）, and UV-Vis analysis （UV-Vis）. All AuNPs/LDHs tested reduced the amount of viral and subviral particles released from treated cells by up to 80% and exhibited good cytocompatibility. AuNPs/MgFeLDH showed the highest antiviral HBV response with more than 90% inhibition of HBV secretion for the whole concentration range. Preliminary studies on the mechanism of HBV inhibition reveals that in the presence of AuNPs/LDHs, HBV particles are sequestered within the treated cells. The antiviral and low cytotoxic plasmonic properties of these Au/LDH nanocomposites indicate that they hold significant potential to be tailored as novel efficient therapeutics for the treatment of hepatitis B.

摘要：Cyanobacteria can produce useful renewable fuels and high-value chemicals using sunlight and atmo- spheric carbon dioxide by photosynthesis. Genetic manip- ulation has increased the variety of chemicals that cyanobacteria can produce. However, their uniquely abundant NADPH-pool, in other words insufficient supply of NADH, tends to limit their production yields in case of utilizing NADH-dependent enzyme, which is quite common in heterotrophic microbes. To overcome this cofactor imbalance and enhance cyanobacterial fuel and chemical production, various approaches for cofactor engineering have been employed. In this review, we focus on three approaches： （1） utilization of NADPH- dependent enzymes, （2） increasing NADH production, and （3） changing cofactor specificity of NADH-dependent enzymes from NADH to NADPH.

摘要：An analysis has been completed for a comprehensive set of vertical,dilute-phase pneumatic conveying pressure drop data from an investigation by *** data were collected in the established flow region for eight different materials conveyed in 0.05-,0.10-,0.20-m internal diameter,20-m tall steel *** velocities derived from the pressure drop data were used to develop an equation of motion that includes terms for pipe diameter,terminal velocity,coefficient of restitution,and particle *** best data fit was achieved using the actual gas density and the actual gas velocity adjusted for *** the terminal velocity for voidage,an approach recommended by many investigators,did not improve the fit for reasons identified by the present *** the equation of motion,particle velocities were predicted and used to calculate total pressure drops that are within±15%of the measured *** calculated values also produce the characteristic trough-shaped total pressure drop curves allowing the minimum pressure drop gas velocity to be determined without recourse to a separate correlation.A comparison with other studies using shorter risers indicates that data from these studies likely include acceleration effects.A separate study will investigate this observation further.

摘要：Wearable biosensors have received great interest as patient-friendly diagnostic technologies because of their high flexibility and *** growing research and utilization of novel materials in designing wearable biosensors have accelerated the development of point-of-care sensing platforms and implantable biomedical devices in human health *** numerous potential materials,conjugated polymers(CPs)are emerging as ideal choices for constructing high-performance wearable biosensors because of their outstanding conductive and mechanical ***,CPs have been extensively incorporated into various wearable biosensors to monitor a range of target ***,fabricating highly reliable CP-based wearable biosensors for practical applications remains a significant challenge,necessitating novel developmental strategies for enhancing the viability of such ***,this review aims to provide consolidated scientific evidence by summarizing and evaluating recent studies focused on designing and fabricating CP-based wearable biosensors,thereby facilitating future *** the superior properties and benefits of CPs,this review aims to clarify their potential applicability within this ***,the fundamentals and main components of CP-based wearable biosensors and their sensing mechanisms are discussed in *** recent advancements in CP nanostructures and hybridizations for improved sensing performance,along with recent innovations in next-generation wearable biosensors are *** wearable biosensors have been—and will continue to be—an ideal platform for developing effective and user-friendly diagnostic technologies for human health monitoring.

摘要：In this work,we adopt a new tobramycin(TOB)-dopamine coating system to endow thin film composite membranes with excellent antifouling and antimicrobial *** the hydrophilic and antibiofouling properties of both TOB and polydopamine,the TOB-dopamine modified membrane exhibits improved antifouling and antimicrobial properties compared with the conventional dopamine modified and unmodified *** TOB-dopamine system has two advantages over the conventional modification with dopamine and tris buffer ***,TOB-dopamine modification is more efficient than the conventional dopamine modification due to the accelerating effect of TOB on dopamine ***,the TOB-dopamine modified membranes exhibit better hydrophilicity,and enhanced antifouling and antimicrobial properties than the conventional dopamine modified *** engineering membranes,the proposed TOB-dopamine system can also be extended for wider surface hydrophilic and antimicrobial modifications.

摘要：A successful qualitative and quantitative analysis of polycyclic aromatic hydrocarbons (PAHs) in air-borne particulates in Hong Kong City has been carried out by the heuristic evolving latent projection (HELP) method recently developed in chemometrics. The resolution result showed that 47 compounds were involved in this sample. Eighteen of them were interesting PAHs and/or their derivatives. The result agreed very well with the one obtained by capillary column GGMS. The resolved UV-visible spectra match well with the standards. With the help of HELP method, accurate quantitative results were also obtained for all the overlapping peaks. The separation ability of chromatography is greatly enhanced by chemometric methods. The HELP method provides a completely new way for quick and accurate analysis of the two-dimensional data produced by hyphenated chromatographic instruments.

摘要：Owing to excellent conductivity and abundant surface terminals,MXene-based heterostructures have been intensively investigated as energy storage ***,elaborate design of the structure and composition of MXene-based hybrids towards superior electrochemical performance is still ***,we present an ingenious leaf-inspired design for preparing a unique Sb_(2)S_(3)/nitrogen-doped Ti_(3)C_(2)T_(x)MXene(L-Sb_(2)S_(3)/Ti_(3)C_(2))***-situ TEM observations reveal that the leaflike Sb_(2)S_(3)nanoparticles with numerous mesopores can well relieve the large volume changes via an inward pore filling mechanism with only 20%outward expansion,whereas highly conductive N-doped Ti_(3)C_(2)T_(x)nanosheets can serve as the robust mechanical support to reinforce the structural integrity of the *** from the structural and constituent merits,the L-Sb_(2)S_(3)/Ti_(3)C_(2)anode fabricated exhibits a fast sodium storage behavior in terms of outstanding rate capability(339.5 mA h g^(-1)at 2,000 mA g^(-1))and high reversible capacity at high current density(358.2 mA h g^(-1)at 1,000 mA g^(-1)after 100 cycles).Electrochemical kinetic tests and theoretical simulation further manifest that the boosted electrochemical performance mainly arises from such a unique leaf-like Sb_(2)S_(3)mesoporous nanostructure with abundant active sites,and enhanced Na^(+)adsorption energy on the heterojunction formed between Sb_(2)S_(3)nanoparticles and Ti_(3)C_2)matrix.