摘要：For further understanding of self-heating of coal, we tested the reactions of seven different ranks of coal under inert atmosphere. In the test, 50-gram of coal sample ranged from 0.18 mm to 0.38 mm was put into a special designed copper reaction vessel and let pure nitrogen to flow into the coal sample from the bottom at a rate of 100 mL/min. The programmed temperature enclosure was run at a programmed rate of 0.8 ~C/min. The concentration of the carbon oxides and the coal temperature were tested. The results show that the coal reactions under inert atmosphere can generate CO and C02. The reactions under inert atmosphere are affected by coal ranks, initial pore structure of coal and sulfur content. For low ranks of coal, the productions of carbon oxides are piecewise. The coal temperature is lower than the surrounding temperature throughout the reactions under inert atmosphere, but it rises quickly and reaches a crossing point temperature in the later stage under dry-air atmosphere. Based on the analysis, it indicates the self-reaction of initial active groups exists in the self-heating of coal besides the reactions in the two parallel reactions model. Spontaneous combustion of coal is due to both the oxidation heat accumulation and the chain reaction. A new reaction model of self-heating of coal was orooosed.

摘要：A further understanding of the self-heating of coal was obtained by investigating the crossing point temperature（CPT） of different ranks of *** tests were carried out using a self-designed experimental system for coal self-heating.50 g（±0.01 g） of coal particles ranging from 0.18 mm to 0.38 mm in size were put into a pure copper reaction vessel attached to the center of a temperature programmed *** temperature program increased the temperature at a rate of 0.8℃/*** air was permitted to flow into the coal reaction vessel at different *** surrounding temperature and the coal temperature were monitored by a temperature *** results indicate that CPT is affected by coal rank,moisture,sulfur, and the experimental *** ranked coals show higher CPT values.A high moisture content causes a delay phenomenon during the self-heating of the *** at 40℃decreases the effects of *** reactivity of sulfur components in the coal is low under dry and low-temperature conditions. These components form a film that covers the coal surface and slightly inhibits the self-heating of the coal. The flow rate of dry air,and the heating rate of the surroundings,also affect the self-heating of the *** most appropriate experimental conditions for coal samples of a given weight and particle size were determined through contrastive *** on this analysis we propose that CPTs be determined under the same,or nearly the same conditions,for evaluation of the spontaneous combustion of coal.

摘要：This study applied the numerical simulator tool FDS （fire dynamics simulator）, Version 5.53, and focused on the simulation of the natural smoke flow ventilation design system, an innovative ventilation design using the parallel processing technology MPI （message passing interface）. The design was then compared with the exhaust efficiency of a typical natural smoke vent. The natural smoke flow ventilation design system was located at the top of the factory, where smoke streams effectively converged. Therefore, the source of fire was designed to be 2 MW, which has a better exhaust efficiency than typical natural smoke vent with same area. The simulation discovered that the exhaust efficiency of the natural smoke ventilation design systems is higher than that of typical natural smoke vent with 2 times the opening area and that was not affected by external wind speed, Instead, external wind speed can help to enhance the exhaust efficiency. Smoke exhaust of typical natural smoke vents was affected by external wind speed, even leading them to become air inlets which would disturb the flow of air indoors, leading to smoke accumulation within the factory.