摘要：With the rapid development in spaceflights and aeroplanes, the demand for low-power and miniaturization techniques has become insistent in modern radar systems. A new framework for low-power modern radar System on a Chip （SoC） based on ASIX core is presented. Pivotal modules and low-power design flows are described in detail. The dynamic clock-distribution mechanism of the power management module and the influence of the chip power are both stressed. This design adopts the SMIC 0.18-μm 1P6M Salicide CMOS process, the area is 7.825 mm x 7.820 mm, there are approximately 2 million gates and the frequency is 100 MHz. The results show that the modern radar SoC passes the test on modern radar application system and meets the design requirements. The chip incurs power savings of 42.79% during the fore-end phase and 12.77% during the back-end phase. The total power is less than 350 mW for a 100-MHz operating environment.

摘要：This paper proposes a kind of programmable logic element(PLE)based on Sense-Switch pFLASH *** programming Sense-Switch pFLASH,all three-bit look-up table(LUT3)functions,partial four-bit look-up table(LUT4)functions,latch functions,and d flip flop(DFF)with enable and reset functions can be *** PLE uses a choice of operational logic(COOL)approach for the operation of logic functions,it allows any logic circuit to be implemented at any ratio of combinatorial logic to *** intrinsic property makes it close to the basic application specific integrated circuit(ASIC)cell in terms of fine granularity,thus allowing ASIC-like cell-based mappers to apply all their optimization *** measuring Sense-Switch pFLASH and PLE circuits,the results show that the“on”state driving current of the Sense-Switch pFLASH is about 245.52μA,and that the“off”state leakage current is about 0.1 *** programmable function of PLE works *** delay of the typical combinatorial logic operation AND3 is 0.69 ns,and the delay of the sequential logic operation DFF is 0.65 ns,both of which meet the requirements of the design technical index.

摘要：A piezoelectric sensor charge/voltage conversion circuit is designed based on the principle that piezoelectric sensor can convert the vibration or shock acceleration into the charge *** of temperature characteristic of feedback capacitor on the switching circuit output is analyzed based on the acquisition and measurement system in this *** characteristics of different filters are analyzed,and the corresponding filter circuit is configured according to the actual sensor *** show that the circuit can effectively filter out noises among the vibration signal and obtain vibration signal accurately.